Eureka 4700 Série Guide Du Propriétaire page 12

Table des Matières

Publicité

G
H
FIG. 8a
F
B
A
12
FIG. 7b
E
FIG. 7a
FIG. 7
FIG. 8
C
FIG. 9
ENGLISH
HOW TO ASSEMBLE
Step 7: Then wrap the hose up and over the hose hook on the handle
shown. Plug the end of the hose into the hose retainer hole on the
E
base
(FIG. 7a) and then snap the hose into the hose holder on
H
the tool caddy
(FIG. 7b).
F
Step 8: Place the dust cup
groove of the dust cup against the tab on cleaner base. Pivot the
dust cup up against cleaner and push to secure as it snaps into
place (FIG. 8).
Step 8A: (in some models only). Place Power Paw™ stair brush in slot in
the special handle holder (FIG. 8).
Step 9: Place the wand/crevice
side of the vacuum. Store the dusting brush
holder on the back of the handle (FIG. 9).
Note: Screws must be installed to properly secure the parts of the vacuum.
(continued)
on the vacuum by aligning the bottom
A
/
B
tool in the wand holder on the
C
on the brush
G
as

Publicité

Table des Matières
loading

Table des Matières