OHAUS ISICMBCDG Mode D'emploi page 8

OPERATING INSTRUCTIONS CONT'D
NOTE: While the unit is capable of reaching 1200rpm, it is recommended that when
using the modular blocks you do not go beyond 600rpm.
4. Setting time to zero (0:00) and continuous mode: Accumulated time.
a. Press and hold the on/off button below the time display. After three (3) seconds
the display will indicate the previous set time.
b. Simultaneously press both the up and the down arrows, the display will indicate
zero (0:00). The unit time is now set to zero (0:00) minutes. Alternately, you can
use the up/down arrows to get to zero (0:00).
c. Press the on/off button below the time display. The display will indicate the
accumulated time. The up/down arrows will become inactive. To stop timer,
press the on/off button again. IMPORTANT: This will NOT interrupt the shaking
function. Press the on/off button below the speed display to interrupt the
shaking function.
d. To reset, press and hold the on/off button below the time display. After three (3)
seconds the display will indicate the previous set time, which was zero (0:00).
5. Setting timed mode: Programmed time.
a. Press the up/down arrows below the time display until you reach the desired
time.
b. Start this funtion by pressing the on/off button below the time display. The unit
will run for the selected time, the up/down arrows will become inactive while
the timer is running. The unit will stop shaking when time display reachers zero
(0:00). Four (4) audible beeps will indicate the count down funstion is complete.
The time display will default back to the set time. To repeat for the same time,
simply press the on/off button again.
c. To interrupt an automatic timing cycle before it is completed, press the on/off
button below the time display. The display will flash off and on to indicate the
time function is on "hold". IMPORTANT: This will NOT interrupt the shaking
function. Press the on/off button below the speed display to interrupt the shaking
function. Restart the timer by pressing the on/off button below the time display.
Unit will continue counting down to zero (0:00). When the display reaches zero
7
(0:00), you will hear the four (4) audiblebeeps that indicate the count down
function is complete and the shaking function will cease.
6. Turning unit off:
a. To turn the unit off, press the standby button. The temperature, speed and time
displays will be blank, the standby indicator light will illuminate. The Incubating/
Cooling Mini Shaker should be kept in standby mode when not in use. To
completely cut off power to the unit, disconnect the power cord from the unit or
unplug from the wall outlet.
OPERATING TIPS
If using modular blocks, it is recommended to secure blocks onto the unit before loading
the samples.
As a safety feature, a built-in program will shut power off to the motor if the tray is
prevented from rotating, or the unit is overloaded beyond its recommended weight
capacity.
The shaker will automatically restart after a power interruption. Built-in memory
maintains the last used temperature, speed and time settings during a power
interruption.
BEEPER PREFERENCE (muting audible alarm)
To silence beeper operation (except for error codes), with the unit in standby mode,
press and hold the time on/off button and press the standby button. Release the
standby button first, and then release the on/off button. To restore normal beeper
operation, remove AC power to unit for ten (10) seconds and then restore.
EN