Control Function; Network - Pioneer BDP-150 Mode D'emploi

Problem
Secondary audio or
interactive audio is not
output.
After a disc is inserted,
Loading stays displayed and
playback does not start.
 is displayed in file names,
etc.
A message indicating low
memory appears while
playing a BD-ROM disc.

Control function

Problem
Control function does not
work.

Network

Problem
• BD-LIVE function
(connection to the Internet)
cannot be used.
• "No valid id file found!" is
displayed when I try to update
the software.
Check
Is HDMI Audio Out properly
set?
Are Digital Output properly
set?
Are there too many files
recorded on the disc?
Check
Is the HDMI cable properly
connected?
Is the HDMI cable you are
®
/
using a High Speed HDMI
TM
Cable?
Is this player connected to
the TV using an HDMI cable
to watch the picture?
Is Control set to On on the
player?
Does the connected device
support the Control function?
Is Control set to On on the
connected device?
Are multiple players
connected?
Check
Remedy
When listening to the sound from an HDMI OUT terminal, set HDMI
Audio Out to PCM (page 35).
When listening to the sound from an DIGITAL OUT terminal, set
Digital Output to Re-encode or PCM (page 34).
When a disc on which files are recorded is inserted, depending on the
number of files recorded on the disc, loading may take several dozen
minutes.
The characters that cannot be displayed on this player are displayed in
.
• Connect a USB device (page 17).
• Erase the data stored on the connected USB device from BUDA
Setup (page 38).
Remedy
To use the Control function, connect the Flat Screen TV and AV system
(AV receiver or amplifier, etc.) to the HDMI OUT terminal (page 14).
® TM
/
Use a High Speed HDMI Cable. The Control function may not work
properly if an HDMI cable other than a High Speed HDMI
used.
If video signals are being output from a terminal other than the HDMI
OUT terminal, the Control function does not work. Connect to the TV
using an HDMI cable (page 14).
Set Control to On on the player (page 35).
• The Control function will not work with devices of other brands that
do not support the Control function, even when connected using an
HDMI cable.
• The Control function will not work if devices that do not support the
Control function are connected between the Control-compatible device
and the player.
• See page 14.
• Even when connected to a Pioneer product compatible with the
Control function, some of the functions may not work.
Also refer to the operating instructions for the connected device.
Set Control to On on the connected device. The Control function
operates when Control is set to On for all devices connected to the
HDMI OUT terminal.
Once connections and settings of all the devices are finished, be sure
to check that the player's picture is output to the Flat Screen TV. (Also,
check after changing the connected devices and connecting and/or
disconnecting HDMI cables.) If the player's picture is not being output
to the Flat Screen TV, the Control function may not work properly.
For details, refer to the operating instructions of the connected device.
The Control function may not work if three or more players, including
this player, are connected by an HDMI cable.
Remedy
Perform Connection Test (page 38). If "Networks is OK." is displayed,
check the proxy server settings (page 38). Also, there may be a problem
with the Internet connection. Contact your Internet service provider.
08
® TM
/
Cable is
47
En