Frigidaire FRSS2323AS Utilisation Et Entretien page 8

8
INSTALLATION
To level the doors using the adjustable
lower hinge:

NOTE
Some models will not have a set screw. For
those models follow steps 2 through 4.
1. Before leveling either door, remove
the set screw that locks the door
height into position. (The door
cannot be adjusted without the set
screw removed).
2. If the refrigerator door is lower than
the freezer door, raise the refrigera-
tor door by turning the adjustment
screw counterclockwise using a
wrench. (See illustration.)
3. If the freezer door is lower than the
refrigerator door, raise the freezer
door by turning the adjustment
screw counterclockwise using a
wrench. (See illustration.)
4. After leveling, verify the door stop
contacts the lower hinge and the
top of the door does not contact the
upper hinge through full movement
of the door (from fully closed to
fully open).
Door Stop
Flange
7/16" Wrench and
3/32" Hex Key (some models)
/ "
7
16
5. Reinstall the set screw, locking the
door height.
6. Replace the toe grille by fitting it
/ "
7
into place (see "Toe Grille Installation
16
and Removal" in the INSTALLATION
section).
Open Door
Hinge
Flange
Set Screw
(some models)
Hinge