Automatic Ice And Water Dispenser - Frigidaire FRSS2323AS Utilisation Et Entretien

18

AUTOMATIC ICE AND WATER DISPENSER

Priming the water supply system
CAUTION
For proper dispenser operation, the
recommended water supply pressure
should fall between 30 psi and 100 psi.
Excessive pressure may cause the sys-
tem to malfunction.
1. Begin filling
the system
by pressing
and holding
a drinking
glass against
the water
dispenser
paddle.
2. Keep the
glass in this
position until
water comes
out of the
dispenser. It may take about
1½ minutes. Water will sputter until
you purge all air from the water lines.
3. Continue dispensing water for about
4 minutes to flush the system
and plumbing connections of any
impurities (stopping to empty the
glass as necessary).

NOTE
Dispensed water is not chilled. For
colder water, add ice to cup or contain-
er before dispensing water.
Ice maker operation & care
After you properly install the refrigerator
and it has cooled for several hours, the ice
maker can produce ice within 24 hours.
The ice maker will fill the ice bin from the
rear. You must dispense some ice to force
the ice forward in the bin. This will allow
the bin to fill completely.
lt e r
r Fi
te
W a e r
Fi lt
p la ce
A ir
R e ce
p la
R e
e n
O p
o r
D o m p
h Te
H ig
g e
u ta
h R
r O u s T E
w e W A
P o C r
b e
C u
E
IC
Dispenser
(varies by model)
Turning the ice maker on
To turn the ice maker on, press the ice
maker's On/Off power switch, located on
the front of the ice maker, so the LED is
steadily illuminated.
IMPORTANT
Turning off the ice maker simply dis-
ables ice making. You will still be able to
dispense existing ice, and you will still be
able to dispense water.

NOTE
The ice maker also has a built-in plastic
signal arm that automatically stops ice
production when the ice bin is full. Do
not use this signal arm to manually stop
the ice maker.