Filter Replacement - Frigidaire FRSS2323AS Utilisation Et Entretien

22

FILTER REPLACEMENT

Pure
Pour™ Water Filter
Keep safe, great-tasting water flowing
Pure
with a Pour™ water filter. Using a
Pure
Pour™ water filter:
• Makes Safe Water Second Nature
Pure
Pour™ water filters are certified
to reduce contaminates* and keep
great-tasting water flowing for you
and your family.
• Produces Purity You Can Trust
Know for certain your
ter filter is a protector. Counterfeits
and knockoffs put your refrigerator
and health at risk. Frigidaire Genuine
Filters are the smarter, safer choice.
• Every Drop Gives Back
Partnered on sustainability efforts,
Pure
the use of a
helps cut back on the cost and use of
plastic used to produce and package
bottled water
*For the complete list, please see Performance
DataSheet on Electroluxappliances.com
Replacing the
Water Filter
The water filter is
located at the top
right side of the re-
frigerator compart-
ment. In general,
you should change
the water filter
every 6 months to
ensure the highest possible water quality.
Water Filter Status on the user interface
prompts you to replace the filter after a
standard amount of water (125 gal/453 L for
Pure
Pour ) has flowed through the system.
™
If you have not used your refrigerator for a
period of time (during moving for example),
change the filter before reinstalling
the refrigerator.
Ordering Replacement Filters
To order your replacement filters, please
visit our online store at Frigidaire.com, by
calling toll-free at 1 (800) 372-4432, or by
visiting the dealer where you purchased
your refrigerator. Frigidaire recommends
that you order extra filters when you first in-
stall your refrigerator, and that you replace
your filters at least once every 6 months.
Here are the product numbers to request
when ordering:
Pure
Pour Water Filter
™
Part# FPPWFUO1™

NOTE
When you order your replacement filter,
please reorder the same filter type
currently in your refrigerator.
Pure
Pour™ wa-
Pour™ water filter
More about your Advanced
Water Filter
Pure
Pour
The
™
tem is tested and certified to NSF/ANSI
Standards 42, 53, 401 and CSA B483.1
for the reduction of claims specified
on the performance data sheet. Visit
Frigidaire.com for more information.
Do not use with water that is microbiologi-
cally unsafe or of unknown quality without
adequate disinfection before or after the
system. Use systems certified for cyst
reduction on disinfected waters that may
contain filterable cysts.
Test & certification results:
• Rated Capacity - 125 gal/453 L for
Pure
Pour and ice and water filter
™
• Rated service flow - .50 gal/min.
• Operating Temp.: Min. 33°F, Max. 100°F
• Maximum Rated Pressure - 100 lbs/in.²
• Recommended Minimum Operating
Pressure: 30 lbs/in²
Pure
To replace your
It is not necessary to turn the water
supply off to change the filter. Be ready
to wipe up any small amounts of water re-
leased during the filter replacement.
Turn Off the ice maker.
1.
2. Remove the filter by pushing on the
end/face of the filter.
3. Slide the old water filter cartridge
straight out of the housing and
discard it.
4. Unpackage the new filter cartridge.
Using the alignment guide, slide it
gently into the filter housing until it
stops against the snap-in connector
at the back of the housing.
5. Push firmly until the cartridge
snaps into place (you should hear a
click as the cartridge engages the
snap-in connector).
6. Press a drinking glass against the
water dispenser while checking for
any leaks at the filter housing. Any
spurts and sputters that occur as
the system purges air out of the
dispenser system are normal.
7. After filling one glass of water, con-
tinue flushing the system for about
4 minutes.
8. Turn On the ice maker.
9. Press and hold the Water Filter reset
button on the Ice & Water Dispenser
control panel for 3 seconds. When
the display changes from red to
green, the status has been reset.
ice and water filter sys-
Pour water filter:
™