Controls And Settings - Frigidaire FRSS2323AS Utilisation Et Entretien

14

CONTROLS AND SETTINGS


NOTE
Your appliance may have some or all of the features listed below. Become familiar
with these features and their use and care.
Press the Cube button to get cubed ice. A white LED light will indicate
Cube the mode is selected. Press glass against the ice dispensing paddle as far
up as possible to catch all the ice.
Press the Crush button to get crushed ice. A white LED light will indicate
Crush
the mode is selected. Press glass against the ice dispensing paddle as far
up as possible to catch all the ice.
Light
Press the light button
will indicate the dispenser light is on. Press again to turn the light off.
To operate the water dispenser, press a glass against the Water
dispensing paddle. To stop dispensing water, pull the glass away from
Water
the dispensing paddle. Dispensed water is not cold. For colder water, add
crushed ice or cubes before dispensing water.
When you need to order a new water filter, the side door UI will change
Water to the Order status. When you need to replace the water filter, the Side
Filter Door UI will change to the red replace status and the front UI will display
Status Replace Water Filter. After you change the filter, hold the Water Filter
button for 3 seconds to reset.
When you need to order a new air filter, the Side Door UI will change to
Air
the Order status. When you need to replace the air filter, the Side Door
Filter UI will change to the red Replace status and the Front UI will display
Status* Replace Air Filter. After you change the filter, hold the Air Filter button
for 3 seconds to reset.
Front of Door User Interface
to turn on the dispenser light. A white LED light
*Only on some models