Stand Basics; Attaching And Removing The Ultrasound System - SonoSite S Stand Série Guide D'utilisation

Stand basics

To raise or lower the ultrasound system
1 Make sure that the area above the column is clear.
2 Turn the height‐adjustment lever counter‐clockwise.
The pole may rise automatically from the column.
3 Raise or lower the pole to the desired height, and then tighten the lever.
To tighten the lever, turn it clockwise.
4 If you want to reposition the lever (for example, parallel to the pole), pull the lever out, turn
it to the desired position, and release.
To lock or unlock a wheel
Push the locking lever on the wheel:
• Push down to lock.
• Push up to unlock.
To adjust the system angle
1 Lock two or more wheels.
2 Using both hands, rotate the system up and down or side to side.

Attaching and removing the ultrasound system

The transducer holder attaches to the system before the system attaches to the stand mounting
plate.
To attach the transducer holder
1 Place the transducer holder on the back of the system, with the cup facing toward the front.
2 Using a Phillips screwdriver, tighten the four screws. See Figure
To attach the ultrasound system
1 Attach the transducer holder to the system.
2 Place the back of the system onto the mounting plate.
The two pegs on the mounting plate pass through the transducer holder and into the two
large holes on the system.
3 Turn the screw in each of the four corners into the system until the system is secure. Use a
Phillips screwdriver if necessary. See Figure
4
2.
3.