Cleaning And Disinfecting - SonoSite S Stand Série Guide D'utilisation

Cleaning and disinfecting

WARNING:
Caution:
To clean and disinfect the stand
You can clean and disinfect the exterior surface of the stand using a recommended cleaner or
disinfectant. For the most recent list of approved products, see www.sonosite.com. Click
Resources and then click Documentation.
1 Remove the system, unplug the power supply, and detach any cables.
2 Clean the surfaces using a soft cloth lightly dampened in a mild soap or detergent cleaning
solution.
Apply the solution to the cloth rather than the surface.
3 Wipe the surfaces with the disinfecting solution.
4 Air dry or towel dry with a clean cloth.
For information about cleaning the peripherals, see the manufacturer's instructions.
8
To avoid electrical shock, before cleaning, always disconnect the system from the
power supply and remove it from the stand.
To avoid injury, always use protective eyewear and gloves when performing
cleaning and disinfecting procedures.
To avoid infection, ensure that the solution expiration date has not passed.
To avoid infection, the level of disinfection required for a product is dictated by the
type of tissue it contacts during use. Ensure that the solution strength and duration
of contact are appropriate for the equipment. For information, see the disinfectant
label instructions and the recommendations of the Association for Professionals in
Infection Control and Epidemiology (APIC) and FDA.
Use only recommended cleaners or disinfectants on surfaces. Immersion-type
disinfectants are not tested for use on surfaces.