Product Description; Power Sources; Battery Installation - LEXIBOOK RL140 Série Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
Top
1. Power button
2. ALARM1 button
3. ALARM2 button
4. VOL- to decrease the volume (V00 to V15)
5. VOL+ to increase the volume
6. SNOOZE/DIMMER/SLEEP button
7. M+/Light button
8. MEM/SET button for clock setting, waveband saving and scanning
9. Previous button <<
10. Next button >>
Front
11. PM indicator
12. SLEEP indicator
13. AL1 indicator
14. AL2 indicator
Your Radio clock operates on AC 230V ~ 50Hz or with 2 x 1.5V
LR03 batteries (not included).

Battery installation

1. Open the battery cover, located at the
bottom of the unit.
2. Insert 2 x 1.5V
batteries observing the polarity markings
inside the battery compartment.
3. Close the battery compartment.(15)
Note: The batteries are backup-only batteries as the clock is supplied with
power through the AC plug.
AC operation
1. Please make sure that the device is switched off.
2. Insert one end of the AC cable (included) to the power input.
3. Plug the other end in a wall socket.
IMPORTANT NOTE: For better performance, it is recommended to use
alkaline batteries with this product.
Non-rechargeable batteries are not to be recharged. Rechargeable batteries
are to be removed from the product before being charged. Rechargeable
batteries are only to be charged under adult supervision. Different types of
batteries or new and used batteries are not to be mixed. Only batteries of the
same or equivalent type as recommended are to be used. Batteries are to
be inserted with the correct polarity. Exhausted batteries are to be removed
from the product. The supply terminals are not to be short circuited. Do not
throw batteries into a fire. Remove the batteries if you are not going to use
the product for a long period of time.
WARNING: Malfunction or loss of memory may be caused by strong frequency
interference or electrostatic discharge. Should any abnormal function occur,
reset the unit, remove the batteries and insert them again or unplug the AC
cable from the wall outlet and plug it in again.

Product description

Power sources

AAA/LR03 type
8
AAA/
1.5 V AAA OU LR03
1.5 V AAA OU LR03

Publicité

Table des Matières
loading

Table des Matières