Product Description; Battery Information - LEXIBOOK RL975 Série Mode D'emploi

Masquer les pouces Voir aussi pour RL975 Série:

Mode d'emploi (33 pages)

Table Des Matières

Table des Matières

Les langues disponibles

1. SOUND: to listen to a nature sound

2. +: to increase digits/the volume/next

3. -: to decrease digits/the volume/previous

4. RADIO: to turn the radio on/off

5. MODE: to switch mode (clock mode/alarm mode)

6. SET: press and hold for 3 sec to enter in the setting mode / press to confirm setting

7. ALARM: to turn on/off the alarm

8. SNOOZE: to activate the snooze function

9. Projector: to turn on/off the projector, gently press the top of the clock with the palm of your hand (the LED

screen will also light up). It will project icons onto the ceiling.

10. Projector button

11. Battery compartment

Your Radio Projector Clock works with 3 x 1.5V

CR2032 type battery (included).

When you use the RL976series for the first time:

1. Open the battery compartment cover located at the back of the

unit.

2. Install the 3 x AA/LR6 1.5V

CR2032 type battery (included) observing the polarity markings

inside the battery compartment.

3. Close the battery compartment.

IMPORTANT NOTE: For better performance, it is recommended to use alkaline batteries with this product.

Non-rechargeable batteries are not to be recharged. Rechargeable batteries are to be removed from the

product before being charged. Rechargeable batteries are only to be charged under adult supervision.

Different types of batteries or new and used batteries are not to be mixed. Only batteries of the same or

equivalent type as recommended are to be used. Batteries are to be inserted with the correct polarity.

Exhausted batteries are to be removed from the product. The supply terminals are not to be short circuited.

Do not throw batteries into a fire. Remove the batteries if you are not going to use the product for a long

period of time. Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.

WARNING: Malfunction or loss of memory may be caused by strong frequency interference or electrostatic

discharge. Should any abnormal function occur, remove the batteries and insert them again.