LEXIBOOK RL140 Série Mode D'emploi page 9

Installation
When unpacking, ensure that the following elements are included:
1 x Radio clock
1 x AC cable
1 x Instruction manual
WARNING: All packaging materials, such as tape, plastic sheets, wire ties and
tags are not part of this product and should be discarded.
Settings
How to set up your CLOCK
1. Once powered on, the Dual Alarm Clock Radio will operate in clock mode.
2. Press and hold MEM/SET button to change the hour.
3. Press previous or next button to choose the hour. Then press MEM/SET
button to register your choice and move to minutes.
4. Press previous or next button to choose the minutes. Then press MEM/SET
button to register your choice.
Note: The Clock Radio displays by default 12 hours clock format.
How to set up/turn off your ALARM
1. To set up your alarm turn off the radio if it is on and press AL1. Once the
alarm activated, the alarm indicator will light up.
2. Press and hold AL1 to enter alarm-clock sound mode. And press next or
previous button to select the buzzer sound (Bu) or radio alarm.
3. If you choose the radio alarm, the frequency last set under radio mode will
be the default. To change the radio frequency, exit the alarm setting mode only
after setting the alarm time and select under radio mode the waveband you
want as alarm.
4. Press AL1 to register your selection and enter alarm time mode. Press next
or previous button to choose the hour.
5. Press AL1 to register your selection and move to minutes. Press next or
previous button to choose the minutes.
6. Press AL1 to register your selection and exit the alarm setting mode.
7. To turn off the alarm, press AL1 and the alarm will repeat every 24 hours
unless the settings are changed. To cancel the alarm setting press once again
AL1.
Note: For AL2, follow the same steps as for AL1.
Note: If you do not press any key for 5 seconds during alarm setting mode, the
unit will exit the setting mode.
The alarm will stop automatically after sounding for 60 minutes without
interruption and will repeat every 24 hours unless the settings are changed.
In case you set AL1 and AL2, the alarm last set only will be automatically
repeating 24 hours after sounding.
The volume of the beep sound is set by default. When the radio alarm rings,
the volume will increase gradually until it reaches the maximum volume (V15).
How to set up DIMMER/SNOOZE mode
· Press DIMMER light (6) to control the brightness of the Clock Radio.
· Press SNOOZE button (6) when the alarm sounds to set up the SNOOZE
mode. The snooze indicator will blink until the alarm replays 9 minutes later. If
you press the POWER button or AL1/AL2 button before the alarm, SNOOZE
mode will be cancelled and the alarm will repeat in the next 24 hours.
9