Steps Of Assembly - SPORTSTECH FX300 Mode D'emploi

STEPS OF ASSEMBLY

!
Firmly tighten all component parts and pre-assembled parts!
STEP 1
Open the box and remove contents.
Place the treadmill (A) on level ground.
Ensure that your work area is clean
and you have adequate space.
EN
STEP 2
Pull out the Rotating Plate (No. A12)
with your right hand. At the same time,
place your left hand at the Handle [Po-
sition B], then pull up the Upright Tubes
(No. A06 and A07).
When pulling up the Upright Tubes (No.
A06 and A07) you can release the Ro-
tating Plate (No. A12). You will hear a
click when the upright tubes are suc-
cessfully locked in.
33