Start the 2in1 cooking
• Plug the appliance, it will make a beep sound and the screen displays "00".
• Choose the cooking program desired for the pan. To select the cooking mode, press the +
button until the required mode 1 to 9 is displayed
• The icon
appears on the screen.
• Press the key
• Choose the cooking program desired for the tray using the + button until the required mode
1 to 9 is displayed
• Press START/STOP key
• You can adjust cooking time at any time by pressing +/- button.
• The cooking of the food in the pan starts.
• The minute by minute countdown starts
• While the food is cooking in the pan, get the food ready for cooking on the tray. Make sure
you do not exceed the maximum level mark on the tray
• When the appliance beeps and stops automatically, open the lid and put the tray in
- fig. 22 &
24.
• Close the lid again
• The minute countdown resumes. The countdown will only be displayed in seconds where
there is less than a minute left.
Remove your food
• When the cooking is finished, the timer will sound and the screen will start flashing and
displaying "00": the appliance automatically stops cooking your food. You can stop the
buzzer by pressing on the start button.
• Open the lid – fig.29.
• Remove the tray with a cooking mitt and take your food out – fig.30. Be careful, the tray is
very hot after cooking. Always use a cooking mitt to remove it.
• Lift up the handle until you hear the "CLICK".
• Remove the pan and take your food out.
Cooking table for 2in1
The cooking times given are a guide only, they may vary depending on the size of the food
items and on how well done you like your food cooked. At the end of the 2in1 cooking time,
if you like your chips or potatoes even more crispy cook them for an few extra minutes after
you've removed the tray.
18
to select the tray mode. The corresponding icon
- fig.
18.
- fig.
19.
- fig. 25
and press the START button.
- fig.
17.
appears on the screen.
- fig.
23.