Replacing Fuse; Power Trim And Tilt Unit Will Not Operate; Fuse, Replacing - Yamaha Motor F175 Manuel De L'utilisateur

Trouble Recovery
EMU41883

Replacing fuse

EWM00632
WARNING
Substituting an incorrect fuse or a piece of
wire could allow excessive current flow.
This could cause electric system damage
and a fire hazard.
If a fuse has blown, replace the fuse accord-
ing to the following procedure.
1. Turn the main switch to the "
position.
2. Remove the fuse box cover.
3. When replacing the main fuse or isolator
fuse, remove the screws, and then re-
move the fuse. Install the spare fuse, and
then tighten the screws.
1. Fuse box cover
2. Spare fuse (10 A, 15 A, 20 A, 30 A, 60 A)
3. Fuse puller
1. Fuel feed pump fuse (10 A)
2. Main switch / PTT switch fuse (20 A)
100
" (off)
1
2
2
3
ZMU07786
7
9
1
2
3
9
4
5
6
8
ZMU07787
3. Starting switch fuse (30 A)
4. Ignition coil / Fuel injector / Variable cam-
shaft timing / Engine ECM (Electronic con-
trol module) fuse (30 A)
5. Electric throttle valve fuse (10 A)
6. Fuel pump fuse (15 A)
7. Main fuse (60 A)
8. Isolator fuse (60 A)
9. Screw
4. When replacing a fuse other than the
main fuse or isolator fuse, remove the
fuse using the fuse puller. Install a spare
fuse of the proper amperage.
1
1. Fuse puller
Consult your Yamaha dealer if the new fuse
immediately blows again.
EMU40984
Power trim and tilt unit will not oper-
ate
EWM02331
WARNING
Never get under the engine while it is tilt-
ed. Severe injury could occur if the out-
board motor accidentally falls.
If the outboard motor cannot be tilted up or
down using the power trim and tilt unit be-
cause of a discharged battery or a failure with
the power trim and tilt unit, the outboard mo-
tor can be tilted manually.
1. Stop the engine.
2. Loosen the manual valve screw by turn-
ing it counterclockwise until it stops.
ZMU04337