Cleaning And Care - B.Braun Aesculap VetCare Exacta GT416 Traduction De La Notice Originale

The comb attachment can be ad-
justed to 4 different cutting
lengths (approx. 3 to 6 mm). To
do so, push it to the required po-
sition on the blade set.
The further you push the comb attachment onto the
blade set, the shorter the cutting length.

5. Cleaning and care

To ensure proper functioning and full performance from
your trimmer, clean and oil the appliance regularly.
Cleaning the blade set
Damage to the clipper head caused by its
removal!
Never remove the clipper head. Once
WARNING
removed it cannot be reattached.
If used regularly, the blade set 5 should be thoroughly
cleaned once a day.
Switch the appliance off.
Remove the comb attachment if fitted.
Use the cleaning brush 12 to remove any hairs.
Oiling the blade set
To maintain the high-quality cutting performance of the
blade set as long as possible, it must be oiled regularly –
preferably daily.
Remove the comb attachment if
fitted.
Lubricate the areas where there
is contact between the upper and
lower parts of the blade set (see
illustration).
Replacing the blade set
The blade set is subject to wear. Even if you look after the
appliance properly, the cutting performance will deteri-
orate. Replace the blade set when it is worn. The blade
set can be ordered separately as a spare part from
Aesculap Customer Service (see addresses at the end of
these instructions).
15