Removing And Cleaning The Filter/ Exhaust Control - Friedrich XSTAR Série Guide D'utilisation

Removing and cleaning the filter/ Exhaust feature
To remove filter
The diagram below (Figure 4) is a guide to filter removal.
Simply turn the unit off and pull the filter frame up and
towards you. Clean with warm water and a mild detergent,
rinse, dry, and replace by sliding the filter back into position
behind the front panel.
Fan
Mode
Speed
Timer Set
Hour
On/Off
Figure 5
Figure 4
Exhaust control
By placing the lever in the EXHAUST (Figure 5) position,
stale air and smoke can be exhausted from the room. This
feature should be used in conjunction with the FAN ONLY
feature to expedite the flow of air to the outside. For normal
cooling, the vent should be in the VENT SHUT position for
maximum performance.
7