Smoke Outlet - Italiana Camini SIMPLI Installation, Usage Et Maintenance

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 17
Fig. 1
B
Fig. 3
C
Fig. 5
E
Fig. 7
G
D
Fig. 9
INSTALLATION
A
Fig. 2
Fig. 4
D
Fig. 6
D
Fig. 8
Fig. 10

SMOKE OUTLET

SIMPLI is prepared for connection to a smoke outlet pipe from
the top, from the back or right or left sides.
The stove is delivered confi gured for the smoke outlet pipe
from the back (Fig. 1).
TO ENABLE ANY CONNECTION SOLUTION OF THE
SMOKE OUTLET CONNECTION TO THE CHIMNEY
FLUE, YOU NEED TO REMOVE THE RELEVANT
METAL SIDE (right or left).
For connections proceed as follows:
- Loosen the four screws on the rear of the side in sheet metal
(A - Fig. 2).
- Remove the two screws from the metal side and remove it (B
- Fig. 3).
At this point, choose the connection of the smoke outlet pipe
necessary (right or left side).
SMOKE OUTLET CONNECTION FROM REAR
Connect the rear smoke outlet pipe (not supplied) to the smoke
outlet spiral (C - Fig. 4-5) using the strip applied.
In this case, simply pass the smoke outlet pipe (not supplied)
through the hole on the bottom of the back of the sheet metal
(Fig. 5).
SIDE SMOKE OUTLET CONNECTION
Assemble the L shaped joint with the strip (not supplied) on the
smoke outlet spiral (D - Fig. 6).
Connect the side smoke outlet pipe (not supplied) to the L
shaped joint as above.
Remove the pre-cut diaphragm from the sheet metal side to
enable passage of the smoke outlet pipe (not supplied) (Fig. 6).
Complete the operation by fastening the closure washer (not
supplied E - Fig. 7) using screws, having re-assembled the side
in metal.
N.B.: fastening the washer and the sheet metal side must take
place after defi nitively fastening the chimney fl ue.
SMOKE OUTLET CONNECTION FROM TOP
Assemble the L shaped joint with the strip (not supplied) on the
smoke outlet spiral (D - Fig. 8).
Connect the smoke outlet pipe (not supplied) to the L shaped
joint as above.
Remove the diaphragm from the small semi-cover in sheet
metal (G - Fig. 9) to enable pipe passage.
ONCE THE SMOKE OUTLET PIPE CONNECTION
OPERATION IS COMPLETE ON THE CHIMNEY
FLUE, RE-ASSEMBLE THE METAL SIDE.
- 98
-

Publicité

Table des Matières
loading

Produits Connexes pour Italiana Camini SIMPLI

Table des Matières