Forza FR304GN Manuel D'utilisation Et D'entretien page 34

Parts and Materials
Burner Base
(Cast aluminum)
Gas Spreader
(Brass)
Burner Cap and Grate
(Porcelain enamel
on cast iron)
Control Knobs
(Zama)
Igniters
(Ceramic)
Suggested Cleaners
Damp cloth.
Detergent and hot water; rinse and dry.
Stiff nylon bristle-toothbrush to clean port
openings.
Abrasive cleansers: Revere ware® metal
polish. Following package direction Use
Brillo® or S.O.S.® pads.
Rinse and dry.
Non abrasive cleaners: Hot water and
detergent, Fantastic, Formula 409. Rinse
and dry immediately.
Mild abrasive cleaners: Bon Ami® and Soft
Scrub®.
Abrasive cleaners for stubborn stains:
soap- filled steel wool pad.
Hot sudsy water: rinse and dry immediately.
If necessary, remove knobs (lift straight
up).
Carefully wipe with a cotton swab
dampened with water, ammonia or
Formula 409®. Gently scrape soil off with
a toothpick.
34
Suggestions/Reminders
Keep the gas injector area free of cleaning
agents and any other material from
entering the injector orifice.
Rub lightly, in a circular motion.
Aluminium cleaners may dull the surface.
To clean port opening, use a tooth brush
or straightened paper clip. Take care not
to damage / augment the shape of the
ports.
The grates are heavy; use care when
lifting. Place on a protected surface.
Blisters/crazing/chips are common due
to the extreme temperatures on grate
fingers and rapid temperature changes.
Acidic and sugar-laden spills deteriorate
the enamel. Remove soil immediately.
Abrasive cleaners, used too vigorously or
too often, can eventually mar the enamel.
Do not soak knobs.
Do not use abrasive scrubbers/cleaners.
Do not force knobs onto valve shaft.
Pull knobs straight away from control
panel to remove.
When replacing knobs, make sure knobs
are in the OFF position.
Do not remove seats under knobs.
Avoid excess water on the igniter. A damp
igniter will prevent burner from lighting.
Remove any lint that may remain after
cleaning.