Draining Condensation Water; Cleaning And Maintenance - Inventum DRS9000AC Mode D'emploi

5

draining condensation water

When the air conditioner is not used for a longer period of time, remove the rubber cap from the drain opening at the
bottom of the appliance and place an empty cup under the outlet.
All the water will flow out of the tank.
The water tank is equipped with an alarm sensor. When the water reaches a certain level in the water tank, the appliance
beeps 8 times and P1 appears in the display. The cooling process is switched off automatically. It is possible that the
appliance continues with air circulation.
Manual discharge - when using the appliance in a room with high air humidity.
1. Remove the plug from the socket.
2. Place a low receptacle under the lower outlet for condensation water
discharge. See the drawing.
3. Remove the screw cap.
4. The water flows out of the drain into the receptacle.
5. Place back the screw cap when no more water is flowing out.
6. Switch the appliance on again.
Continuous discharge - recommended when using the dehumidification position.
1. Remove the plug from the socket.
2. Remove the screw cap. Keep a drip tray at hand when removing the screw cap
in order to collect the condensation water that may come out of the outlet.
3. Connect the discharge hose (1/2" or 12.7 mm). See drawing.
4. The water is discharged continuously via the discharge hose.
5. Switch the appliance on again.
Condensation water can also be discharged as described on page 12, at section
DEHUMIDIFICATION.
6

cleaning and maintenance

Before cleaning the air conditioner, switch off the appliance by means of the ON/OFF key, wait a few minutes and remove
the plug from the socket.
Cleaning the exterior
Clean the exterior of the appliance with a slightly damp cloth and then wipe it with a dry cloth. If necessary, you can clean
the exterior of the appliance by means of a mild washing-up liquid.
• Never wash the appliance with water. This can be dangerous.
• Do not use petrol, alcohol or similar solvents to clean the appliance.
• Never spray with insect sprays or similar agents.
• Do not use aggressive or abrasive cleaning agents for cleaning the appliance.
• Never submerge the appliance, cord or plug in water or any other liquid.
Cleaning the air filter
In order to allow the appliance to function as well as possible, we recommend cleaning the
air filter every week. The air filter could get clogged with dust and dirt. Remove the air filter
as shown in the drawing.
Use a vacuum cleaner to remove all the dust from the air filter.
If the air filter is very dirty, you can clean it with lukewarm water.
• Submerge the air filter in lukewarm water (max. 40°C) containing a soft cleaning agent.
Rinse the air filter a few times and allow it to dry in the air. Do not place the air filter
in the sun or on the heating to dry it.
• Place back the air filter. Check that it is fully dry, before using the appliance again.
Cleaning the air inlets
In order to allow the appliance to function as well as possible, you can clean the air inlets
by means of a vacuum cleaner with a soft brush nozzle.
drain opening
drain opening
31
English •