Opex Sure Sort Traduction Des Instructions Originales page 126

2.4.1.1. Restarting the machine after an E-stop event
Only an Authorized Employee is permitted to perform this procedure.
Once an E-Stop has been pressed, an Authorized Employee will perform the
following steps to restart the machine:
1. Inspect the machine to determine the cause of the emergency or accidental
stoppage.
2. If repairs are required, lock out/tag out the machine per
(LOTO) Procedures" on page
3. Repair the fault, and verify that the machine is safe to operate.
4. Remove all tools and other materials from the area.
5. Ensure the machine is closed up and operationally intact.
6. Notify affected persons that the machine will be restarting.
7. Make sure everyone is safely away from the machine.
8. Pull up on the E-Stop button to deactivate it.
9. If the front and/or rear stacker door was opened, press the Reset button to
reset the interlock.
10. In the Run screen of the host software, clear the jam and restart the
machine.
Safety
WARNING
69.
Sure Sort™ Operator Manual
OPEX Corporation
"Lockout-Tagout
63