Unpacking, Inspection, Testing - ETA Systems 420VA Guide De L'utilisateur

ETA Systems ® - SECURITY ONE UNINTERRUPTIBLE POWER MANAGER
are at full load with a healthy battery. Partial loads and/or aged batteries will affect the accuracy of this timer
setting.
Receptacle On/Off Control: Set the turn-off times of the receptacle groups and individual receptacles on
the rear panel.
Start Manager
When AC power is not available, such as in a new installation where wiring may be incomplete, you can still
start the UPM to test its operation and the operation of your system using Start Manager. With the UPM off,
follow these simple steps:
1. Disconnect the input AC power cable from the rear panel of the UPM.
2. Ensure that the battery enable plug(s) are inserted into the rear panel battery enable socket(s).
3. Press and hold the On/Off switch on the front panel until the UPM beeps.
4. The UPM is now running on battery. When you have finished, press the On/Off switch again. Plug the
input AC power cable into the rear panel of the UPM.
7.0 – UNPACKING, INSPECTION, TESTING AND TROUBLESHOOTING
Please Note: Before installation, please read and understand the following instructions. Carefully examine
the packing carton for damage. Notify the carrier immediately if damage is observed. Be sure to save the
carton should you ever need to ship the UPM for repair or maintenance.
Placement
This UPM is intended for indoor use only. Although your UPM is very rugged, its internal
components are not sealed from the environment. The UPM must be installed in a
protected environment away from heat producing appliances such as furnaces, radiators,
and heaters. Protect the UPM from exposure to dripping or standing water and high
humidity or condensing air conditions. The location should provide adequate airflow
around the UPM. Provide a minimum 1" clearance on all sides for proper ventilation.
12