Maintenance Cleaning; What Should I Do If - Atag OX611T Mode D'emploi

maintenance
cleaning
Use the enamelled baking tray as a drip-tray when grilling.
cleaning after use
For cleaning both the inside and the outside of the oven, it is
best to use a mild cleaning agent (washing-up liquid) and a
damp cloth.
Dry with kitchen paper or a dry cloth.
Never use abrasive agents. These may harm the enamel or
cause scratches.
stubborn stains
You can remove stubborn stains with a liquid abrasive or oven
cleaner.
Remove burnt-on food inside the oven with a glass scraper.
The glass panel on the inside of the door is removable. If the
oven has been built in under the worktop, it may be that the
glass panel cannot be taken out of the door. You can clean
the window on the inside by sliding a cloth between the two
panes.
The glass panel's guides on the inside of the oven door may
become discoloured if they come into contact with oven
cleaner. Read the directions on the packaging of the oven
cleaner before use.
cleaning accessories
Use a mild cleaning agent. Dry the accessory well with a dry
cloth. Any burnt-on food on the grill set can be removed
using steel wool.
GB 22
If the appliance does not work properly, this does not always mean that it is defective.
Try to deal with the problem yourself first. Phone the service department if the advice
given below does not help.
fault cause
The clock does not work No power supply.
(see page 25).
Fuse in the meter cupboard
defective.
Oven or grill does not heat Fuse in the meter cupboard
up. defective.
End-time set.
Temperature is not correct. Temperature set incorrectly.
Thermostat defective.
Oven light not on. End-time set.
No power supply.
Bulb defective.
Oven switches off suddenly. Working-time limiter has
switched the oven off.
faults

what should I do if...

solution
Insert the plug in the socket.
Replace the fuse.
Replace the fuse.
The oven switches on
automatically.
Set the oven temperature
again.
Switch oven off and phone
the service department.
The light will come on when
the door is opened and when
the oven switches on.
Insert the plug in the socket.
Switch oven off and replace
the bulb. Disconnect the
appliance from the power
supply by removing the plug
from the socket or by turning
the main switch in the meter
cupboard. You can snap the
glass cover out of the side
wall of the oven. The bulb is
then accessible. Replace it
with a new bulb 230 V-50 Hz-
300 °C.
Reset the oven.
GB 23