hestan KWD Instructions D'installation page 19

INSTALLATION
CUSTOM DRAWER FRONT (-OV MODELS) CUSTOM DRAWER FRONT (-OV MODELS)
CUSTOM PANEL REQUIREMENTS: CUSTOM PANEL REQUIREMENTS:
• Have a minimum thickness of 3/4" [19 mm].
• Have all edges finished.
• If using wood, the back must be sealed to prevent moisture damage.
• Be capable of withstanding temperatures above 158° F [70° C].
PREPARING CUSTOM DRAWER FRONT PREPARING CUSTOM DRAWER FRONT
1. Mark pilot holes on the back side of the panel according to the dimensions indicated in the
following drawing.
2. Drill pilot holes with a 3/32" [2.5 mm] drill bit. Be careful not to drill all the way through the
panel. Pilot holes should only be 7/16" [11 mm] deep.
B C
=
DIMENSIONS
[CONT.]
D
PILOT HOLES
7/16" (11 mm)
INCHES
A 29 - 5/ 8" to 29 - 7/8"
B 10 - 3/ 8"
C 7 - 5/ 8"
D 8 - 3/16"
D D
A
dia. 3/32"
(2.5 mm)
CM
75.4 to 75.8
26.4
19.3
22.4
©2021 Hestan Commercial Corporation
EN
=
17