Cleaning And Maintenance - hestan KWD Instructions D'installation

CLEANING AND MAINTENANCE

DRAWER SLIDES DRAWER SLIDES
The drawer slides allow you to fully extend the drawer for cleaning. The drawer can be removed
for cleaning or to replace the interior lights.
NOTE: Load capacity for the drawer is 80 lbs [36 kg].
Remove all items from inside the warming drawer, and allow the warming drawer to cool
completely before attempting to remove the drawer.
TO REMOVE: TO REMOVE:
1. Open drawer to its fully
open position.
2. Using a Phillips screwdriver,
remove 2 screws present
under the left and right
guides as shown.
3. Hold the drawer by
the sides (not by the
front). Pull it slowly
all the way out.
TO REPLACE: TO REPLACE:
1. Extend the two sliding guides
manually from the inside of the
drawer. Support the drawer, one
person on one side, the other per-
son on the other side. Place the
drawer on the extended guides.
2. Holding the sliding guide steady
with one hand, slide the drawer
inwards until the rear pin engages
(Fig. A)
3. Using a Phillips screwdriver,
reinstall the left and right screws
under the guides.
4. Push the drawer all the way.
Gently open and close the drawer
to ensure proper operation on the
slides.
Fig. A
©2021 Hestan Commercial Corporation
EN
11