Manual Setting; Volume Adjustment (Drc); Deleting Inactive Stations - TechniSat DIGITRADIO 20 CD Mode D'emploi

7.2.7 Manual setting

This menu item is used to check the reception channels and can be used to position
the antenna.
> Briefly press the MENU button and use the SCROLL&SELECT knob in the
[DAB menu] submenu to select the [Manual setting] item. Press the
SCROLL&SELECT knob to make your selection.
> Select a channel (5A to 13F) using the SCROLL&SELECT knob. The signal
intensity will now be shown on the display. If a DAB+ station is being received
on a channel, the station ensemble name is displayed. The antenna can now
be aligned to the maximum signal intensity.
Stations with a signal intensity below the required minimum signal intensity
are not transmitting a strong enough signal. Align the dipole antenna if
required as described in Section 4.3.3.

7.2.8 Volume adjustment (DRC)

With the Volume Adjustment menu item, the compression rate is set which balances
the dynamic variations and thereby the accompanying volume variations.
> Press the MENU button and select the [DAB menu] submenu and the
[Volume adjustment] item.
> Press the SCROLL&SELECT knob to select the item.
> Select the compression rate by rotating the SCROLL&SELECT knob:
DRC high -
DRC low -
DRC off -
> Confirm by pressing the SCROLL&SELECT knob.

7.2.9 Deleting inactive stations

This menu item is for removing old stations and those no longer being received from
the station list.
> Press the MENU button and in the [DAB menu] submenu select the [Delete
inactive stations] item.
> Press the SCROLL&SELECT knob to select the item.
This is followed by the [Delete] prompt asking if the inactive stations are to be
deleted.
> Using the SCROLL&SELECT knob, select the [Yes] item and confirm by
pressing the SCROLL&SELECT knob.
22
High compression
Low compression
Compression switched off.