Operating Modes - Kemper KHS CoolFlow Manuel D'utilisation

EN
4.4
Delete evaluations
4.5 Operating
Edit operating mode
Change operating mode
Precondition:
• You are in Installer mode.
48 / 144 – K410061000000-00 / 02.2022 – © www.kemper-olpe.de
Evaluation
1.
Select operating mode
The correct controller function according to the
Auto current temperatures and the set parameters is
only assured in Automatic mode.
Manual switching of relay outputs and connected
Manual mode consumers for function testing by plumbing specia-
lists is possible.
OFF Controller functions are deactivated.
Warning!
In manual mode there are no controller logic and no
protection mechanisms. Therefore, this should only be
active for a short time.
2.