Installing The Heat Sink - Dell OptiPlex 7080 Micro Mode D'emploi

2. Remove the side cover.
3. Remove the front bezel.
4. Remove the fan assembly.
About this task
The following images indicate the location of the heat sink and provide a visual representation of the removal procedure.
Steps
1. Loosen the three captive screws that secure the heat sink to the system.
NOTE: Loosen the screw in the sequential order (1,2,3) as printed on the heat sink.
2. Lift the heat-sink from the system board.

Installing the heat sink

Prerequisites
Si vous remplacez un composant, retirez le composant existant avant d'exécuter la procédure d'installation.
36 Démontage et remontage