Installing The M.2 2230 Pcie Solid-State Drive - Dell OptiPlex 7080 Micro Mode D'emploi

3. Remove the front bezel.
4. Remove the hard-drive
About this task
The following images indicate the location of the solid-state drive and provide a visual representation of the removal procedure.
Steps
1. Remove the screw (M2x3.5) that secures the solid-state drive to the system board.
2. Slide and lift the solid-state drive off the system board.

Installing the M.2 2230 PCIe solid-state drive

Prerequisites
Si vous remplacez un composant, retirez le composant existant avant d'exécuter la procédure d'installation.
About this task
The following image indicates the location of the solid-state drive and provides a visual representation of the installation procedure.
26 Démontage et remontage
assembly.