Humidity Settings - JFRMEDICAL Humidifier Notice D'utilisation

Note!
When installing the water chamber, do not allow any water to spill into the
humidifier or therapy device. Use only room temperature distilled water in the
chamber. Do not put any chemicals or additives into the water. Possible airway
irritation or damage to the water chamber may result.
Caution
5.2 Humidity Settings
The heating control and the status can be found on the display of the therapy
device. Please refer to the relevant section in the user manual of your therapy
device.
6
• Do not fill the water chamber above the maxi-
mum fill line. If the water chamber is overfilled,
water may leak into the therapy device, humidi-
fier, or onto your furniture. Damage to the humidi-
fier or therapy device may occur.
• No chemicals in the water.
• Never touch the heating plate on the humidifier
cradle. Never touch the heat transfer plate on the
bottom of the water chamber. These plates can
reach temperature as high as 74°C during opera-
tion.
• The heating plate must be turned off from Humid-
ifier Settings when the device is being used with-
out water.
• Never place the device on a soft surface such as
a bed or couch during operation. Do not position
it where it may be stepped on when getting out of
bed.
• The height of the system must always be lower
than the interface mask during use to prevent
water from getting into the mask.
SET UP