JFRMEDICAL Humidifier Notice D'utilisation page 11

Clean all parts of the water chamber
with mild soapy water.
Rinse all parts of the water chamber
with clean water.
Allow the individual parts to dry
completely before reassembly.
Insert the sealing gasket(11) into the
groove on the water bowl. Inspect the
fitting of the gasket to ensure it is fully in
place and the sealing gasket handle is
on the top left side.
Snap the water bowl and cover together
by inserting the tabs slightly on the bowl
into the slots on the cover. Gently push
down the cover and lock the water
chamber with the clamps on both sides.
Note!
Use only mild soapy water to clean the components!
Do not use any solutions that contain bleach, chlorine, alcohol, scented oils or other
aromatic‐based ingredients to clean the humidifier components. These solutions
may reduce the life of the product.
8
5.
6.
7.
8.
9.
Note!
Inspect the sealing gasket(11) before each
use to ensure that it is properly seated in
the groove around the entire chamber and
the sealing gasket handle is on the bottom
left side.
2.
SET UP
11
1.
3.