Barazza FWD 40e Notice D'utilisation Et De Montage page 9

Sink mount flange installation
Remove the sink waste trap (fig. 1)with a screwdriver and
scrape the left over
Garbage disposer installation
Loosen the hinged clamp (6)and levering with your hands
remove the garbage disposer flange, unscrew the mount ring
(5) and take the flange washer away. (4)
A. Put the sink flange (2)in the discharge sinkhole, taking care that the black flange gasket
sets perfectly well. If it's not a stainless steel sink but a synthetic or a ceramic one, you better
apply a thin coat of sanitary stopper instead of flange gasket.
.
B Under the sink: you need to firmly seat and attach the mounting ring which has three screws
used to tighten the mounting ring (4-5-6) assembly so it will apply firmly to the sink bottom
C. Join the garbage disposer to the flange and put the hinged clump in position (D) To facilitate
insertion between the garbage disposer and the flange put some cooking oil on the border of the
guard-splash.
A.
Plumbing Connection
Attach the disposer discharge tube with the tube flange using the given screw.
Connect the garbage disposer discharge tube (see fig.E) and tighten it to the drain trap
(ex. F.1-F.2)
To avoid problems, before connecting the plumbs, control the tubes cleaning them if
needed.
E.
Pag. 9
plumbers putty used to seal the sink
B.
F.1
Fig. 1
C.
F.2
(3)
D.