Barazza FWD 40e Notice D'utilisation Et De Montage page 10

Electric connection
All models are preset to operate at 220-240V/ 50 Hz.
See to it that the feeding tension corresponds to the said value.
Make sure that a proper socket is installed under the sink. If not, fit it up.
HOW TO FIT THE PNEUMATIC SWITCH KIT (not included in the package)
The kit consists of:
•
One (chromium-plated) folded switch
•
One angular metal bracket
•
One meter long PVC connecting tube
How to fit the switch:
1. Either make a 35mm diameter hole on the top of the sink or fix the bracket by
means of the screws in the proper position.
2. Unscrew the fastening ring nut of the folded switch.
3. Insert the switch into the hole or the bracket. Fit the gasket
from underneath and fasten it by screwing again the plastic
ring nut.
4. Insert one end of the PVC connecting tube into the beak of
the folded switch and connect the other end to the beak of
the air switch placed on the base of the disposer (see the
side picture) after having unscrewed its guard nut. Finally
screw again the guard nut.
The disposer is now ready to be used.
Press only once the folded switch to carry out the switching on and the turning off.
It is alternatively possible to install one REMOTE CONTROL
Before carrying out the connection make sure that:
•
The feeeding plant is provided with an efficient earth connection as
provisions of the law in force.
•
The socket and the switch being utilized can be easily reached by the installed appliance. See to
it they cannot be reached by children.
•
Into the electric plant there is one differential switch having a nominal value of minale
10A/0.03A to prevent any indirect contact (automatic circuit breaker).
IN CASE OF NON COMPLIANCE WITH THE ACCIDENT PREVENTION RULES WE WOULD DECLINE ANY
Pag. 10
RESPONSIBILITY
per the rules and the