Safety Instructions - Barazza FWD 40e Notice D'utilisation Et De Montage

SAFETY INSTRUCTIONS

The waste disposer has an overload protection.
If an object falls into the housing or if there is overload the waste disposer stops automatically. You
should operate as follows:
1. Put the switch of the plant in the OFF position or unplug it.
2. Insert the hex wrench (Fig.12) into the opening at the bottom of the motor shaft and rotate the
tool and the counter clockwise to unblock the food waste disposer(Fig. 13)
3. Remove the object or the overload.
4. Wait for 5/10 minutes.
5. Push the red reset disposer bottom (Fig. 14) and restart the machine.
Fig. 12
DISPOSER MAINTENANCE
With normal usage your disposer should not require any special care.
The motor is permanently lubricated and will not require oiling under normal usage conditions. If
used according to the operating instructions above, your disposer should not require cleaning.
However should it start to smell grinding a tray of ice cubes in the disposer will clean the grinding
components. Grinding a lemon cut into quarters will also give your disposer a fresh, clean smell.
Dishwasher Connection (Fig.11)
It is possible to connect the dishwasher discharge
tube with the food waste disposer Ø 25mm.
With the help of a screwdriver and a rubber
hammer remove the plastic stopper positioned in
the inner site of the dishwasher connection.
Fasten the dishwasher discharge tube to the
garbage disposer
Pag. 12
Fig. 13
If used in a proper way the will last for years
Fig. 14
Fig. 11