VONROC LM501AC Traduction De La Notice Originale page 12

EN
Depending on the preferred cutting height, you
can adjust the wheel assembly in one of three
positions.
1. Put the lawn mower on its side.
2. Grasp the wheel axle on both sides.
3. Pull evenly on the axle and insert into one of the
three notches, as shown on figure L. Ensure the
left and right side of the axle are mounted in the
same notch. Repeat this step for both axles. En-
sure the front and rear axle are mounted in the
same notch, so the lawn mower cuts parallel to
the lawn.
4. Each notch position resembles a cutting height,
as shown on figure M.
Position 1 resembles a cutting height of 25 mm.
Position 2 resembles a cutting height of 40 mm.
Position 3 resembles a cutting height of 55 mm.
Note: A higher cut height should be selected for the
first cut of the season.
Securing the power cord (Fig. A, N)
Mount the cable into the cable strain relief (5) as
shown on figure N.
Switching the machine on/off (Fig. A, O)
Do not start the mower if it is standing in
long grass.
• To start the machine, press and hold the safety
button (3) and press the on/off switch (2).
Whilst holding the on/off switch (2), you can
release pressure on the safety button (3).
• To stop the machine, release the on/off switch
(2) and wait until cutting blade stops rotating.
Always work your way away from the cables to
avoid cutting them, as shown on figure Q.
5. MAINTENANCE
Maintenance
Your mower has been designed to operate over a
long period of time with minimum of maintenance.
Continuous satisfactory operation depends upon
proper mower care and regular cleaning.
• Keep the mower clean and dry.
• Regularly use a blunt scraper to remove grass and
dirt from the mower
• To clean the mower, use only mild soap and a
12
damp cloth. Never let any liquid get inside the tool
and never immerse any part of the tool into liquid.
Do not use any abrasive or solvent - based cleaner.
ENVIRONMENT
Faulty and/or discarded electrical or
electronic apparatus have to be collected at
the appropriate recycling locations.
Only for EC countries
Do not dispose of power tools into domestic waste.
According to the European Guideline 2012/19/EC
for Waste Electrical and Electronic Equipment and its
implementation into national right, power tools that
are no longer usable must be collected separately
and disposed of in an environmentally friendly way.
WARRANTY
VONROC products are developed to the highest
quality standards and are guaranteed free of
defects in both materials and workmanship for the
period lawfully stipulated starting from the date of
original purchase. Should the product develop any
failure during this period due to defective material
and/or workmanship then contact VONROC directly.
The following circumstances are excluded from this
guarantee:
• Repairs and or alterations have been made
or attempted to the machine by unauthorized
service centers;
• Normal wear and tear;
• The tool has been abused, misused or
improperly maintained;
• Non-original spare parts have been used.
This constitutes the sole warranty made by company
either expressed or implied. There are no other
warranties expressed or implied which extend
beyond the face hereof, herein, including the implied
warranties of merchantability and fitness for a
particular purpose. In no event shall VONROC be
liable for any incidental or consequential damages.
The dealers remedies shall be limited to repair or
replacement of nonconforming units or parts.
The product and the user manual are subject to
change. Specifications can be changed without
further notice.
WWW.VONROC.COM