Bestway 58497 Manuel Du Propriétaire page 13

Filter:
This function is used to filter pool
water and should be positioned here 99% of the
time. Water is pumped through the sand filter,
where it is cleaned and returned to the pool.
A
Backwash:
clean the sand bed; water is pumped
down through the Collector Hub, upwards
through the sand bed, and deposited out
of Port D.
A
Drain:
This function drains water from the
pool; another filter bypass setting, water is
pumped and deposited out of Port D, instead of
returning it to the pool.
A
NOTE:
• Be sure all provisions for wastewater disposal meet applicable local, state or
national codes. Do not discharge water where it will cause flooding or damage.
• When the Control Valve is set to the Backwash, Rinse, or Drain position, water
will discharge from Port D on the Control Valve.
C
B
This function is used to
C
D
B
C
D
B
Closed:
flowing between the sand filter and the
pool.
A
Rinse:
cleaning, and sand bed leveling after Backwash;
water is pumped downwards through the sand
bed, up through the Collector Hub and
deposited out of the valve Port D.
A
Circulate:
water by passing the sand filter; use this
function if the filter is broken to collect debris
in the Debris Screens.
A
13
This function stops water
C
B
This function for initial startup,
C
D
B
This function circulates pool
C
B