Smart Battery Charger - HC Cargo 161026 Mode D'emploi

GB
MULTI-USE SMART BATTERY CHARGER
READ ENTIRE MANUAL BEFORE USING THIS PRODUCT
HC-CARGO no. 161026
SPECIFICATIONS
Input Voltage
Output Current (Max.)
Charge Voltage (Max.)
Weight
Size
FEATURES
1. Battery Clip Cable Assembly
2. Ring Terminal Cable Assembly
3. LED Indicators 2
4. Mounting Holes
IMPORTANT SAFETY INSTRUCTIONS
READ AND SAVE THIS SAFETY AND INSTRUCTION MANUAL
1. This manual contains important safety and operating instructions for this battery charger/
maintainer. Please read, understand and follow these instructions and precautions carefully.
2. Use this charger only on 12 volts LEAD ACID, AGM and GELLED ELECTROLYTE (GEL-CELL) batteries.
Do not attempt to use on other voltages and types of batteries (DRY CELL, NICKEL CADMIUM,
NICKEL METAL HYDRIDE, etc.) commonly found in small home appliances. This may cause chargers
and batteries to burst, resulting in damage or injury to person and property.
3. Do not expose this charger to direct sunlight, rain or snow.
4. If the battery is installed, please make sure that the vehicle is turned off all loads and no loads
are presented.
5. Do not use attachments to this charger that are not recommended. Non-recommended attach-
ments may result in injury, electric shock, or fire and voids the warranty.
6. To reduce risk of damage to electric plug and cord, pull by plug rather than cord when disconnect-
ing charger.
7. If it is necessary to use an extension cord, it should be properly grounded cord. Use of improper
extension cord could result in a risk of fire and electric shock.
8. Do not operate charger with damaged cord or plug – replace the cord or plug immediately.
9. Do not operate charger if it receives a sharp blow, been dropped, or otherwise damaged in any
way; take it to an authorized service center for repair.
10. Do not disassemble charger; take it to an authorized service center for repair when service or
repair is required. Incorrect reassembly may result in a risk of electric shock or fire.
11. To prevent injury during cleaning or maintenance, disconnect all batteries and move them to clear
access to the unit. Unplug this charger from the wall outlet. Use a slightly dampened cloth to
clean the housing and lead sets. Do not use solvents or soaps.
12. Place the power cords in a location where will not be stepped on, tripped over, or subjected to
stress or abuse of any kind.
220 - 240Vac
5A
14.8V
1.1 lbs
17'' L x 7.3'' W x 4.8'' H
2
161026
Vedpak 196_Version 1_18.07.14