Getting Started - AEG SB2 Série Mode D'emploi

Getting started
GB
1. Before first use: Clean the blender
according to the instructions in
"Cleaning and Care", see page 26.
Fill the bottle with ingredients.
Caution! Do not exceed the
maximum filling volume: 600
ml. Do not mix dough, mashed
potatoes, meat etc.
4. Turn the bottle upside down.
Push down the bottle into the
blender base and rotate it counter-
clockwise to lock.
Note: When locked, the symbol
on the blender assembly should be
aligned with on the blender base.
Caution! To reduce risk of injury,
never place the blade assembly
on the base without the bottle
properly attached.
2. Fasten the blade assembly on the
open end of the bottle, by turning
it counter-clockwise.
Caution! The blades and inserts
are very sharp!
5. Push and hold the On-Off button
to start mixing. The indicator light
will illuminate until the On-Off
button is released. Release the On-
Off button to stop mixing.
Caution! If the motor stalls, turn
the blender off immediately,
unplug the appliance and let it cool
for at least 10 minutes.
3. Place the blender base on a flat,
level surface. Plug into a power
outlet.
6. When the ingredients are fully
mixed: Release the On-Off button
to stop mixing. Make sure the
motor has stopped completely,
then turn the bottle clockwise to
loosen it. Remove the bottle from
the blender base. Replace the
blade assembly with the drinking
lid.
D
GR
NL
F
GB
21