Thermador DWHD650G Série Instructions D'installation page 23

Problem Cause
Dishwasher not ill- 1. Restriction in the water supply system.
ing with water 2. Previous wash cycle was not completed.
3. Delay-start is active.
Water Leaks 1. Suds
2. Door seal could be pulled away from track.
3. Condensation vent is blocked.
4. Improper installation.
Tub stains 1. Stains on the dishwasher interior are due to hardness of
water.
2. Silverware in contact with tub.
Streaks on glass- Incorrect rinse agent setting.
ware or residue on
the dishes
Fascia panel discol- Abrasive cleaner used.
ored or marked
Noise during wash The dishes may not be arranged properly.
cycle
Detergent dis- 1. Improper operation of detergent cover.
penser cover will 2. Previous cycle has not been inished, reset, or cycle was
not shut interrupted.
Unable to select Previous cycle has not inished or another cycle has already
desired cycle started.
Error Codes If fault code (E01 to E30) is indicated on the digital display 3 , irst disconnect the appliance from the power supply. You can rectify certain
faults yourself (see following fault description), for all other faults please contact customer service and state the indicated fault E:XX.
Water is left in the 1. (E24) Waste water hose is blocked or kinked.
appliance 2. (E25) Waste water pump blocked, cover on the waste
at the end of the water pump is not locked in position
3. Filters blocked.
cycle
4. The cycle has not yet ended.
Action
1. Ensure that the water supply valve (typically located under kitchen
sink) is open and check that the water supply line has no kinks and
clogs.
2. Refer to "Interrupting the cycle" (pg.17) in the "Operating the unit"
section of this manual.
3. Cancel the delay-start or wait until delay-start time completes
(times out). Refer to "Delay Start" (pg. 17) in the "Additional features"
section of this manual.
1. Wrong type of detergent results in suds and leaks. Use only dish-
washer detergents. If suds still persist, then add one tablespoon of
vegetable oil at the bottom of the dishwasher and run the desired
cycle.
2. Ensure that door seal is in the track.
3. Ensure that condensation vent is not blocked. Refer to "Extra-Tall-
Item Sprinkler" (pg.12) in the "Operating the unit" section of this
manual.
4. Have proper installation veriied by qualiied personnel (water sup-
ply, drain system, leveling, plumbing).
1. Concentrated Lemon juice can reduce the build up of hard water
stains. Run a normal cycle until it lushes and interrupt the cycle and
then place an 8 oz. cup of the concentrated lemon solution on the
top rack and inish the cycle. This can be done periodically to avoid
build up.
2. Ensure that the silverware does not make contact with the tub
while running a cycle.
Depending on the hardness of water, adjust the rinse agent dispenser.
Refer to the "Rinse agent" (pg.8) section in this manual for adjustment.
Use mild detergents with soft damp cloth.
Water circulation sound is normal, but if you suspect items are banging
into each other or into the spray arms, refer to the "Loading your dish-
washer" (pg.10) section of this manual for optimal arrangement.
1. Refer to the "Detergent" (pg.7) section of this manual for instruc-
tions on opening and closing the dispenser.
2. Refer to "Interrupting the cycle" (pg. 15) in the "Operating the unit"
section of this manual.
Refer to "Interrupting the cycle" (pg. 17) in the "Operating the unit" section
of this manual.
1. See the "Maintenance and care" (pg. 18) section of this manual.
2. Wait until cycle ends (digital display indicates 0:00).
22