Thermador DWHD650G Série Instructions D'installation page 18

Cycle Completion Signal
The cycle completion is indicated by a tone. This function can be changed as follows:
• Open the door.
• Turn unit on by pressing [ON/OFF].
Hold down [NORMAL] and press and hold [START] until the display shows "H:00".
•
• Release both buttons.
• Press [NORMAL] until the display shows "b:02".
• Press [QUICK CLEAN] to increase or decrease the tone "b:00" = of and "b:03" = loudest.
• Press [START] to save the setting.
• Close the door.
Intensive Drying
The inal rinse uses a higher temperature which improves the drying result.
The running time may increase slightly. (Use caution if utensils are delicate!)
• Open the door.
• Turn unit on by pressing [ON/OFF].
• Hold down [NORMAL] and press and hold [START] until the display shows "H:00".
• Release both buttons.
• Press [NORMAL] until the display indicates "d:00".
Press [QUICK CLEAN] to turn on intensive drying "d:01"= on and "d:00"= of.
•
• Press [START] to save the setting.
• Close the door.
Auto Power Of
To save energy, the dishwasher is turned of 1 minute after the wash cycle ends. Auto Power Of can be adjusted from
P:00 to P:02.
To change the factory setting (P:01):
• Open the door.
• Turn unit on by pressing [ON/OFF].
• Hold down [NORMAL] and press and hold [START] until the display shows "H:00".
• Release both buttons.
Press [NORMAL] until the display indicates "P:01".
•
• Press [QUICK CLEAN] to change auto power of setting. "P:00" = dishwasher does not turn of automatically,
"P:01" = dishwasher turns of after 1 minute, "P:02" = dishwasher turns of after 120 minutes (2 hours)
• Press [ ] to save the setting.
START
• Close the door.
To change the language:
• Open the door.
• Turn unit on by pressing [ON/OFF].
• Hold down [NORMAL] and press and hold [START] until the display shows "H:00".
• Release both buttons.
• Press [NORMAL] until the display indicates "L:01".
• Press [QUICK CLEAN] to change auto power of setting.
"L:02" = English "L:03" = French "L:07" = Spanish
• Press [ ] to save the setting.
START
• Close the door.
17