Koala Kare KB311-SSWM Instructions D'utilisation page 7

KB311-SSWM
Installation Instructions
Fig. 8
Fig. 9
*Diagrams are not to scale.
Step 7:
• With the unit open take the liner dispenser and
position it over the exposed metal frame in the
center of the flange.
• Use the provided key to open the liner dispenser.
This will provide access to the four mounting holes.
• Use the provided hardware to secure the liner
dispenser to the metal frame. Fig. 8
• Lock the liner dispenser and close the unit.
Step 8:
• Take the provided handle and position it over the
handle mounting studs.
• Use provided Allen wrench to tighten the set screws
in the handle, securing it to the handle mounting
studs. Fig. 9
Step 9:
• Test the unit by opening and closing multiple times,
ensuring it opens and closes smoothly.
• Remove protective film from the surface of the unit.
Step 10:
• To install the bag hook, measure up 44" (1118mm)
from finished floor in the desired location and mark
the wall.
• Position the bag hook on the wall so that the top of
the mounting plate is level with the 44" (1118mm)
mark.
• Position the bag hook over a wall stud for optimal
Fig. 10
strength.
• Mark then predrill the mounting holes. Fig. 10
• Use the provided screws to secure the bag hook in
position, then take the escutcheon plate and screw
Fig. 11
it over the mounting plate to cover the mounting
screws. Fig. 11
7 7