Installation Of Double Deck Models - Garland Master Série Manuel D'installation, D'utilisation Et D'entretien

INSTALLATION Continued

Installation Of Double Deck Models

A. Position insert in bottom leg opening and tap insert up
into leg till it seats at collar. Attach six inch (6") legs to
lower oven section. Raise unit or lay on its left side. Place
the front legs on the oven so as to line up with four (4)
attaching bolt holes. Secure leg to oven frame using (4)
3/8-16 x 3/4 bolts and washers provided. Repeat at rear of
unit.
B. Remove lower front cover of top deck (located under oven
doors). Raise top deck into place and line up body sides
and back of the unit. Fasten the rear of the units together,
with the stacking bracket, using (6) 1/4-20 machine
screws, lock washers and nuts, (provided).
C. Install the interconnecting fl ue parts, carefully following
the instructions contained in the stacking kit. Pay
particular attention to the type of ovens you are stacking
and be sure to follow the corresponding instructions.
D. Assemble the stacking pipes provided in the stacking
kit as shown in the diagram at the top of this page. This
allows both ovens to be supplied by a single gas line. The
minimum recommended size of a single supply line for
two stacked ovens is 1 inch. Use a pipe thread compound
that is intended for use on propane gas piping and be sure
to check for leaks before fi nalizing the installation.
E. Check leveling of unit four (4) ways (using a common
carpenter's level on the rack inside the oven).
F. Plug the cord set of each unit into a separate 115-Volt
power supply outlet.
G. Maintain clearance from combustibles.
Each gas appliance shall be located with respect to building
construction and other equipment so as to permit access to
the appliance. Such access and clearance may be necessary
for servicing and cleaning.
8
90 Degree Street Elbow
20-1/2" Nipple
3" Nipple
3/4" Union
3" Nipple
90 Degree Street Elbow
CAUTION:
DISCONNECT BOTH UNITS FROM
ELECTRICAL SUPPLY BEFORE SERVICING.
POWER FAILURE
In the event of a power failure, no attempt should be
made to operate this oven.
IMPORTANT
All gas burners need sufficient air to operate and large
objects should not be placed in
front of this oven, which would obstruct the airflow
through the front. Objects should not be placed on main
top rear of oven while in use. This could obstruct the
venting system of the unit's flue products.
3/4" to 1" Bell Reducer
Part Number 260BGS rev B 4/15