Installation And Start-Up - Watts OneFlow OF744-10 Manuel D'installation, De Fonctionnement Et D'entretien

Installation and Start-up

IN
Cold Water
OneFlow
Figure 1.
Model OF844-12 shown with
optional bypass assemby.
OUT
Treated Water
®
Bypass Valve Modification
Service Position
down-flow tank.
Service Position
UP-flow tank.
1. Place the system in the desired location.
2. Connect the cold water supply to the inlet of the OneFlow
system.
NOTE: The OneFlow
®
which is opposite of a conventional softener.
3. Place a bucket under the outlet port or run a line from the
outlet port to a drain.
5. Slowly open the supply valve (user supplied) to the
OneFlow system. Allow the tank to fill with water. Close the
®
supply valve when a steady stream of water comes out of
the outlet port.
6. Connect the outlet of the OneFlow
water supply of the building.
7. Open the supply valve to the OneFlow
8. Open faucets downstream from the OneFlow
relieve any air.
9. Check for leaks. Repair as needed.
10. The system is now ready for service.
As shipped, the bypass is set-up for down-
flow use. The arrow shape of the handles
points in the wrong direction for UP-flow
use. To convert it to UP-flow use, pull up on
the red handles until they come off. Rotate
the handle 180° and put it back on the valve
stem.
5
system operates in the UP-flow mode
system to the cold
®
system.
®
system to
®
Bypass Position
UP-flow tank.
®