Care And Cleaning; Troubleshooting - Schulthess Perla GS 55i Swiss eMotion Notice D'utilisation

Care and cleaning

Warning! Before maintenance,
deactivate the appliance and
disconnect the mains plug from the
mains socket.
Cleaning the filters
C
B
Cleaning the spray arms
Do not remove the spray arms.
If the holes in the spray arms are clogged,
remove remaining parts of soil with a thin
pointed object.

Troubleshooting

The appliance does not start or it stops
during operation.
Before you contact the Service, refer to the
information that follows for a solution to the
problem.
C
A
A1
A2
External cleaning
Clean the appliance with a moist soft cloth.
Only use neutral detergents. Do not use
abrasive products, abrasive cleaning pads
or solvents.
With some problems, the display
shows an alarm code:
•
Dirty filters and clogged spray arms de-
crease the washing results.
Make a check regularly and, if neces-
sary, clean them.
1. Turn the filter (A) counterclock-
wise and remove it.
2. To disassemble the filter (A),
pull apart (A1) and (A2).
3. Remove the filter (B).
4. Wash the filters with water.
5. Put the filter (B) to its initial posi-
tion. Make sure that it assem-
bles correctly under the two
guides (C).
6. Assemble the filter (A) and put it
into position in filter (B). Turn it
clockwise until it locks.
An incorrect position of the fil-
ters can cause bad washing re-
sults and damage to the appli-
ance.
- The appliance does not fill with wa-
ter.
51