Daily Use - Schulthess Perla GS 55i Swiss eMotion Notice D'utilisation

48
4. Press button (10) again and again to
change the setting.
Filling the salt container
Filling the rinse aid dispenser

Daily use

1. Open the water tap.
2. Press the on/off button to activate the
appliance. Make sure that the appliance
is in setting mode, refer to 'SETTING
AND STARTING A PROGRAMME'.
• If the salt indicator is on, fill the salt
container.
A B
A
+ -
C
D
5. Deactivate the appliance to confirm.
1. Turn the cap counterclockwise and
open the salt container.
2. Put 1 litre of water in the salt container
(only for the first time).
3. Fill the salt container with dishwasher
salt.
4. Remove the salt around the opening of
the salt container.
5. Turn the cap clockwise to close the
salt container.
Caution! Water and salt can come out
from the salt container when you fill it.
Risk of corrosion. To prevent it, after
you fill the salt container, start a pro-
gramme.
1. Press the release button (D) to open
the lid (C).
2. Fill the rinse aid dispenser (A), no more
than the mark 'max'.
3. Remove the spilled rinse aid with an
absorbent cloth to prevent too much
foam.
4. Close the lid. Make sure that the re-
lease button locks into position.
You can turn the selector of the re-
leased quantity (B) between position 1
(lowest quantity) and position 4 (high-
est quantity).
• If the rinse aid indicator is on, fill the
rinse aid dispenser.
3. Load the baskets.
4. Add the detergent.
5. Set and start the correct programme for
the type of load and the degree of soil.