Installing The Water Dispenser Line - Samsung RS25J50 Serie Mode D'emploi

Wrench Wrench

Installing the water dispenser line

A water dispenser is one of the helpful features on your new Samsung Refrigerator.
To help promote better health, the Samsung water filter removes unwanted particles from
your water.
However, it does not sterilize or destroy microorganisms.
You may need to purchase a water purifying system to do that.
The water line also connects to the ice maker.
For the ice maker to operate properly, water pressure of 20 ~ 125 psi (138 ~ 862 kPa) is
required.
If the refrigerator is installed in an area with low water pressure (below 20 psi), you can
install a booster pump to compensate for the low pressure.
After you have connected the water line, make sure the water storage tank inside the
refrigerator is properly filled.
To do this, press the water dispenser lever until water runs from the water dispenser.
NOTE
• Water line installation kits are available at extra cost from your dealer.
We recommend using a water supply kit that contains copper tubing.
DA68-02981N-00.indb 31 DA68-02981N-00.indb 31
Bolt Bolt
3 2
Nut Nut
1
3. After adjusting the doors, turn the nut
(1) clockwise (
lower end of the bolt, then tighten the
bolt again with the wrench (3) to fix the
nut in place (1).
NOTE
• If you do not secure the nut firmly, the
bolt may release.
) until it reaches the
English 31
2015. 3. 3. 2015. 3. 3. 9:34 9:34