Use As Directed; Prohibited Use - Kollmorgen PCMM AKC-PCM-Mx Mode D'emploi

1.2.2 Use as Directed

PCMMs are intended for controlling Kollmorgen drives in a motion system.
PCMMs are components that are built into electrical plants or machines and can only be oper-
ated as integral components of these plants or machines. The manufacturer of the machine
used with a PCMM must generate a risk assessment for the machine.
When the PCMMs are built into machines or plant, the motion system must not be used until
it has been established that the machine or plant fulfills the requirements of the regional dir-
ectives.
Cabinet and wiring
PCMM must only be operated permanently connected in a closed control cabinet suitable for
the ambient conditions (➜ # 12). Ventilation or cooling may be necessary to keep the tem-
perature within the cabinet below 55 °C.
Use only copper conductors for wiring. The conductor cross-sections can be derived from the
standard IEC 60204 (alternatively for AWG cross-sections: NEC Table 310-16, 75 °C
column).
Power supply
The PCMM can be supplied by 24V DC industrial supply networks.

1.2.3 Prohibited Use

Other use than that described in chapter "Use as directed" is not intended and can lead to per-
sonnel injuries and equipment damage. The PCMM may not be used with a machine that
does not comply with appropriate national directives or standards. The use of the PCMM in
the following environments is also prohibited:
potentially explosive areas
environments with corrosive and/or electrically conductive acids, alkaline solutions, oils,
vapors, dusts
PCMM Installation Manual | 1 English
Kollmorgen | kdn.kollmorgen.com | February 2018 7