Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
The following table shows possible problems and their causes:
Problem, cause, remedy
Problem
Machine does not
a
start
b
Low stroke rate
c
Stroke rate too high
Gear makes loud
d
noise
Strong vibration
e
during cutting
f
Other problems
We ask you to send the machine to the manufacturer, if necessary.
Unless otherwise specified, our "General Sales Terms" apply. Warranty and liability claims in
regards to persons or equipment damages are invalid, if one or more of the following causes
apply:
•
Improper use of the machine,
•
improper assembly, startup, operation or maintenance of the machine,
•
operation of the machine with defect safety devices or improperly fixed or non•functioning
safety and protection devices,
•
not considering of the instructions in the operating instruction booklet concerning transport,
storage, assembly, startup, operation, maintenance and setting up of the machine,
independent structural alterations or settings on the machine beyond the intended purpose,
•
inadequate supervision of wear parts,
•
improperly carried out repairs, inspections or maintenance,
•
catastrophic cases due to foreign objects, acts of god or other reasons which are beyond our
control.
TROUBLESHOOTING
Cause
Not connected to compressed
air
Operating pressure too low
Hose diameter too small
Flow rate too low
Operating pressure too high
Flow rate too high
Bearings and pinions worn out
or broken
Wrong saw blade selected
Feed rate too high
Dull saw blade
-
WARRANTY AND LIABILITY
Remedy
Connect and open the supply
line
Increase operating pressure
Choose larger hose diameter
Increase flow rate
Consider max. operating
pressure acc. to technical
specification
Reduce flow rate
Contact authorized expert
company
Use appropriate saw blade
Reduce feed rate
Replace saw blade
Contact authorized expert
company
51
Publicité
Table des Matières
