Ega Master 79617 Manuel D'instructions page 39

Start and stop
Twist or release
Fig.4
Fixing example
Reciprocating saw with clamping device.
After finishing the sawing work
• Shut twist throttle.
• Shut compressed air supply and disconnect air hose.
• Take saw out of the device.
• Clean saw and retainer seat.
• Inspect machine for damages.
prevents from splicing
Fig.6
Steel wire
Use of sticky tape
with without
Pull the locking device and slide
the saw onto the bearing bolt of the
clamping device until the locking
device snaps into place.
Profile
Use of wedge
prevents from pinching
Fig.5
Bearin bolt
Fig.7
39