Preliminary Operations; Pellet Loading; Electrical Power Supply; Power Off - termovana Anna Manuel D'utilisation

11 PRELIMINARY OPERATIONS

11.1 PELLET LOADING

The first operation to be carried out before turning
the appliance on is to fill the tank with fuel (pellets),
preferably using a scoop.
Be careful not to touch the hot parts if fuel refilling
is carried out with the stove running.
Do not empty the bag directly into the tank to
avoid loading sawdust or other foreign elements
that could compromise correct functioning of the
stove and to avoid dispersing the pellets outside
the tank itself.
Be sure to close the lid of the tank well after loading
the pellets. The safety pressure switch (for models
with outside air intake) verifies proper closure (fig.
3.1) and sends an alarm if the lid is left open for
more than 20 seconds with the stove running.

11.2 ELECTRICAL POWER SUPPLY

Connect the stove to the mains power, operate the
ON switch on the back of the stove, positioning it
to "I" (fig. 3.2). If the connection is properly made,
the display will light up.
During long periods of non-use, it is recommended
to position the switch on the back of the machine
to OFF (O).
Do not touch the control panel when the stove is
being powered.
11.3 IGNITION
Before each ignition, make sure that the burn pot
is completely empty and correctly positioned in its
seat.
To turn on the stove hold the
few seconds.
Avoid manually turning on the stove if the automatic
ignition system is compromised.
During initial ignition of the stove it is possible to
generate unpleasant smells or fumes caused by
the evaporation or drying of some of the materials
used. This phenomenon will gradually disappear.
During the first lightings, we recommend that you
keep the premises well ventilated.
Do not pour pellets directly into the burn pot.
Stoves in the "Hermetic" series:
Each time the fire box door and pellet tank
door is opened, avoid leaving it open for long
periods to prevent the closure sensor from
notifying the open door status with an acoustic
alarm.

11.4 POWER OFF

To turn off the stove hold the
few seconds.
It is advisable to wait for the stove to completely
cool before re-igniting it again.
The stove should always be turned off strictly in
accordance with the above, and absolutely not by
disconnecting it from the mains power.
key pressed for a
11.5 OPERATION WITH AMBIENT PROBE
key pressed for a
02/2021 - EN
ATTENTION: Do not insert fuel through the
aeration outlets.
ON STOVE
The stove can be switched on/off manually or in a
programmed way.
The stove modulates the power depending on
the ambient temperature measured by the on-
board probe (that is, the stove tries to maintain
the desired temperature, consuming as little as
possible).
If the user has enabled the "Standby" function,
rather than modulate, the stove will turn off
when the set temperature is reached, then
re-ignite when the ambient temperature falls
below the set delta.
The desired ambient temperature can be set using
the keys .
- 3.1 -
- 3.2 -
21